首页
搜索
历史搜索
HOME > SERVICE > Problem > I/O

232 interface description and common problems of dam series products

2022-03-09 17:52:27| | 0

1. There are three common RS232 interfaces of dam series equipment:

DB9 female head:

88.png

Terminal wiring:

89.png

DB9 head interface pin is defined as follows:

90.png

232 terminal pin is defined as:

Note: the terminal wiring is, and the 5-pin GND of 232 must be connected.

RX Data receiving
TX Data transmission
GND/negative and

2. Computer connection

When connecting the computer for communication, the user needs to check whether there is a db9232 male interface on the computer, as shown in the figure:

91.png

If not, you need to use a 232 to USB converter. When using the converter, the USB driver needs to be installed on the computer. The specific driver files need to be obtained by contacting the converter manufacturer, or use the driver master, driver wizard and other software to identify the installation.

3. How to view the serial port number of the current computer

Right click59.png, select [attribute]60.png, and then click to view in [port], as shown in the following figure:

93.png

4. Device communication connection

After determining the port number, open the dam debugging software, select the corresponding serial port number, select the equipment model, enter the default equipment address, and open the serial port to conduct communication test, as shown in the following figure:

94.png

5. Communication failure performance

The software reads the parameter prompt and fails to read. At this time, the first step is to check whether the serial port cable or the serial port to USB adapter cable is normal.

6. How to test whether the serial port cable and RS232 to USB cable are normal

95.png

Open the serial port assistant at the computer end and send data arbitrarily. If the weak serial port line is normal, the sending and receiving data content and length are the same, as shown in the figure:

96.png

联系销售
销售王经理微信 销售王经理
微信公众号 微信公众号
服务热线
400-6688-400